Timer based Automatic Drain valve
Condensate Sensing Drain Valve
Refrigeration type Compressed Air Dryer
Desiccant- Heatless type Air Dryer
Large Desiccant Compressed Air Dryer
Sub-micron Filtrers
Vertex Dryer
Reciprocating Air Compressor
Non-Lubricated Air Compressor
Vacuum Pump
Rotory Screw Air Compressor
Large Reciprocating Compressor
Tractor Compressor
Cooling Tower
Nitrogen Generator & Tyre Inflator
Servo Stabilizer
Isolation Transformer
Distribution Transformer
Energy Saver & Power Factor Controller

.::Vortex Dryer ::.

The Concept
Vortex Dryer eliminates 100% water in liquid phase. Air is termed as dry air as long as there is no water in liquid condition. Vortex Dryer removes and evaporates water thereby assuring 100% liquid-water-free air. This process does not lower the dew point. Any cooling after Vortex Dryer will result in condensation. Hence these dryers are to be used near the end use machines.


>> Removes Wate, Oil & Solid particles
>> Compact and lightweight
>> No Electricity used
>> All aluminium chambers increase cooling effect.
>> Large Surge Chamber


How it works

The Vortex Dryer is a highly efficient two stage air filteration and drying system using the principle of Coalescent Filtering and Micro-Vortex Motion.

In the first stage, coalescence takes places as wet, oily and dirty air is made to spin and tumble through an indepth-bed made of Stainless Steel fine wire. Moisture in the air condenses into droplets by centirifugal force, which along with other contaminants travel down the wire to the bottomof the filter cartridge and on to a honeycomb structure. Water subsequently drains out.

Compressed air leaving the first stage contains only trace quantities of moisture, oil vapour and particles of size lesser than 10 microns. In the second stage air enters a tightly wound filter element made up of highly absorbent, long staple cotton backed by S S wires for it breaks down into small vortices called Micro Vortices. This phenomenon is known as Vortex Shedding. Small micro vortices are formed with a vaccum where water particles are trapped. Then the water particles disintegrate and evaporate. Another phenomenon also takes place simultaneously by which reamaning water particles are dried by the flowing air through Absorbed and Dry principle. This results in 100% elimination of liquid water content.

Oil droplets coalesce in the first stage, while oil vapour is absorbed by the second stage elements, effectively removing 99% of oil content. A filteration efficiency of 100% is achieved for solid particles of 5 micron size and 50% for 1 micron size.


>> Pneumatic Tools
>> Spray Painting
>>Sand/Shot Blasting
>>Air Equipments


Max. Flow: 25 CFM
Max. Working Pressure: 15 Kg/Sq.Cm.
End Connection: 1/2" BSP
Dimention (HxBxD) mm: 200 x 100 x 50
Weight: 1.25 Kgs.
Air inlet condition: Max. Fluid temp. 70 Deg.C
Sealing: Potyurethane & Nitrile Rubber

All Rights Reserved to Reach Pneumatics. 2010-11